I'm working on a little shelf layout, and I want a small steam engine to run occasionally. It's a switching layout, so I think a 2-8-0 is the biggest I'd go for, and if it's a tank engine that's even better. Since I need to buy basically all my materials and supplies in one go instead of dipping into a built-up stockpile, I'm looking for something on the cheaper end.

Hi All,

Went to see some trains today with my camera.  Found a couple scenes that you might enjoy looking at. 

In the spirit of the holidays I'd like to share them with You.

Hope the ensuing year is Happy, Healthful and Prosperous for you.

I’m looking forward to see and enjoy your prototype photos too again this year.  

I truly enjoyed the last couple years photos.  Thanks!

Nick

I could use a few pointers on installing a light (led or bulb) into a brass steam engine headlight.  The light will be controlled by a TCS decoder, so a led or bulb can be accounted for by CV's.  I need to drill one or two small holes for the wire, thus the problem.  How do I detach the headlight assembly from the boiler in order to drill the holes.

Hey folks. We acquired a whole bunch of trains and I'm having a difficult time identifying these two engines. Please be gentle, I'm just learning.

As you can see, Loco #1 is hollow inside and has a "2" cast into it. It is 6-1/8" long.

Loco #2 is solid on the front half and weighs just under 1.5lb and is 6-3/8" long.

Thank you in advance for helping a newby learn the ropes.